From dca2c2a439e225bf46dbbdfbe8e46d31acf611c6 Mon Sep 17 00:00:00 2001 From: wanleg <32079073+wanleg@users.noreply.github.com> Date: Sat, 30 Jun 2018 06:35:45 -0700 Subject: readme update to wanleg layout (#3266) --- keyboards/gherkin/keymaps/wanleg/readme.md | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) (limited to 'keyboards/gherkin/keymaps/wanleg') diff --git a/keyboards/gherkin/keymaps/wanleg/readme.md b/keyboards/gherkin/keymaps/wanleg/readme.md index bfdf56febe..0b1b099c4a 100644 --- a/keyboards/gherkin/keymaps/wanleg/readme.md +++ b/keyboards/gherkin/keymaps/wanleg/readme.md @@ -70,8 +70,10 @@ On a Gherkin, B4/F7 corresponds to the top-left corner key. You can add `#define QMK_SPEAKER C6` if you have a speaker hooked up to pin C6. The Gherkin PCB already uses pin C6 in its switch layout, so you cannot use a speaker on a standard Gherkin. 4. Also, you should add `BOOTLOADER = qmk-dfu` to your `rules.mk` file, so it is flagged properly. Again, this is already set up in `qmk_firmware/keyboards/gherkin/wanleg`. 5. Once you've made the required edits, it's time to compile the firmware. If you use the `:production` target when compiling, it will produce the usual `.hex` file as well as `_bootloader.hex` and `_production.hex` files. The `_production.hex` will be what we want. This contains the bootloader and the firmware, so we only have to flash once (rather than flash the bootloader, and THEN flash the firmware). -For example: -`make gherkin/qmkdfu:wanleg:production` +For example +`make ::production` +For my particular keymap, for reasons listed in the **Using QMK DFU** section, you should use the following to ensure the bootloader is set properly +`make gherkin:wanleg:production dfu=qmk` ## Burn QMK DFU 6. Navigate to the directory with your `_production.hex` file, and burn it with the following command -- cgit v1.2.1